Medema Mini Crosses M2 4W Cabin User Manual download pdf (Page 30)

User guide P9-0152-B 30 of 60 Version 3.0.0/2013

Medema Production A/S

New batteries do not reach full capacity until they have been

charged and discharged about 20 times.

It is IMPORTANT to ﬁ t the batteries correctly. The battery

terminals and snap locks are marked +/-. They must be ﬁ tted

as shown in the sketch below. Make sure that the snap locks

are properly closed. For the same reason there must not be any

burrs on the terminals.

The Mini Crosser should be charged while not in use. The

charger supplied from the factory switches over to trickle

charging (very low power consumption) automatically when the

batteries are fully charged. You can therefore leave the charger

connected until the Mini Crosser is next used. The charger

cannot overcharge the batteries.

The charger will ﬂ ash until charging is complete. Then it will

show a steady light.

The charger must not be placed on the seat during charging.

IMPORTANT! Never use charging devices other than those

supplied from the factory without ﬁ rst contacting the dealer.

NEUTRIK NC3MX charging plug Connect the charging plug to the 3-pin

socket on the steering column. The

charging socket is located under the

protective cover.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 59 60

No comments

Medema Mini Crosses M2 4W Cabin User Manual Page 30